It is made up of one or more belt conveyors that transport the trims produced by the log-saw. For each log cut, two trims, one on either end, are discarded. The trims are left to fall by Trimex gravity that transports the rolls to the log-saw outfeed.

The first conveyor belt loading zone is then positioned at the end of the flight conveyor under the Trimex. First conveyor outfeed can be on the front of the log-saw (under the roll outfeed) or at the side, depending on the requirements and log-saw overall dimensions.

Trims transported outside the log-saw can be unloaded on another conveyor or near the trim suction unit.

If a REDS divider coupled to the logsaw is present, the trims shall be unloaded at the side. If there are two parallel log-saws, it is possible to collect the trims from both log-saws on one line.

FRONTAL TRIM OUTFEED FROM 1 LOG-SAW CONVEYOR
LATERAL TRIM OUTFEED FROM LOG-SAW WITH A REDS DIVIDER
TRIM OUTFEED FROM 2 LOG-SAWS